Cold Vulcanized Rubber Pulley Lagging
Availability: in stock
Trade with confidence on Abraa
Safe and secure payments using Abraa safe trade systems
Supplier verification not completed
Pay only through Abraa to stay protected. Never pay a supplier by direct transfer.
Secure Payment
Pay through Abraa, never by direct transfer to a supplier.
Product Inspection
Book a check before shipping to confirm quality and quantity.
Buyer Protection
Get support and refunds if goods arrive not as described.
Verified Suppliers
Licence, address and on-site checks by the Abraa team.
Product Specification
Product Descriptions
| Specific Gravity | 1.25 Gm/cm3 |
| Standard Length | 10 Mtr, 33 Ft, 11 Yard |
| Standard Thickness | 6 mm to 40 mm |
| Standard Width | 1.2, 1.4, 1.5 Mtr, 48", 54", 60" inches |
| Country of Origin | Made in India |
| Is It Transparent | Non Transparent |
| Tensile Strength | Upto 20 MPa |
| You Supply In | Sheet, Roll |
| Thickness | 3mm - 30 mm |
| Brand | Rabbit |
Rubber lagging is manufactured using an abrasion-resistant top rubber layer and a buffed CN bonding layer to provide high levels of adhesion. Cold bonding is the process of gluing strips of rubber lagging straight onto the steel pulley. This technique has been used for many years due to its convenience and cost-efficiency. Cold bonding is less involved compared to hot vulcanizing and can be performed on-site when sudden lagging problems arise. If done properly, cold bonding can provide satisfactory results for light to medium pulley applications. However, cold bonding doesn’t offer 100% rubber tear adhesion which means service life is somewhat reduced.
\
Similar Products
View all
