DUSEEL R 200 H Protective Coating Membrane

DUSEEL R 200 H is a high quality, quick setting bitumen emulsion protective coating manufactured from the combination of high quality bitumen, rubber and chemical emulsifying agent. The rubber content gives the emulsion a strong consistency that forms upon drying, elastic and highly effective liquid applied protective coating membrane.

FEATURES AND BENEFITS

• Excellent elastomeric liquid applied membrane.
• Penetrates and seals porous substrate.
• Excellent damp proofing and waterproofing property.
• Excellent adhesion to substrate.
• Seamless coating.
• Water based no health hazard.
• Forms a tough and resilient film upon drying.
• High resistance to dilute acids and alkalis.
• Non-toxic and odorless.
• Excellent adhesion on damp and dry surfaces.
• Solvent free, no fire hazard. 

SPECIFICATION COMPLIANCE

DUSEEL R 200 H is tested in accordance of ASTM D 2939 and other relevant International Standards.

QUALITY ASSURANCE AND WARRANTY

Duproof is ISO 9001 Quality Assured Company, and DUSEEL R 200 H carries a material warranty against any manufacturing defects

MAIN USES

DUSEEL R 200 H is used as

• An excellent damp proofing and protective coating for concrete roofs, columns and beams.
• Damp proofing of foundations, manholes and other underground concrete structures.
• Chemically resistant to be used as protective lining on gutters for effluents, acids and alkalis in industrial factories.
• The high elasticity of the product makes it a superior protective coating, liquid applied membrane. 

METHOD OF APPLICATION

Substrate Preparation

1. All substrate must be clean, free from dirt, dust, soil, grease, oil and other loose particles. Substrates that are very dry should be applied with a penetrative coating of DUPRIME E. If the concrete is very dry, dampen first with water.
2. Stir the emulsion thoroughly if stored for a long time.

Application System on Porous substrate (Concrete Structure)

1. Prime the surface with water based primer DUPRIME E and allow the primer to dry completely (6-8 hours).
2. Apply a minimum of 2 coats by brush or spray equipment.
3. The second coat is applied when the first coat has completely dried.
4. Apply each coat at a right angle to the previous coat to achieve good coverage and uniformity.
5. A third coat is required for very porous substrate.
6. Drying time is 1-4 hours under normal conditions. Under damp and cold conditions it is recommended to allow 6 hours between successive coats. 

Emulsified Bitumen is recommended to be applied at temperatures above 5°C.

PACKING AND STORAGE

DUSEEL R 200 H is available in 20 liter pails and 200 liter drums, palletized and strapped. Store at temperature between 5°C and 50°C in a tightly sealed container. Shelf life is minimum of 1 year in a good storage protected from direct sunlight and frost